ForcedFirebird
NKOTB
Won a bet!
fabrication thread
- Thread starter repentharlequin
- Start date
ForcedFirebird
NKOTB
Why remove paint? Welding dirty.
---------- Post added at 12:51 AM ---------- Previous post was at 12:47 AM ----------
I was 32 5yrs ago, so I'm old. 16ga mild steel to cast iron.
---------- Post added at 12:57 AM ---------- Previous post was at 12:51 AM ----------
Go ahead buy ebay...
Last edited:
ForcedFirebird
NKOTB
Tried it yesterday. They are back together, but need more practise for it to look nice.
Tinfoil is next on the list.
I went fmic and its wayyyy to big to put stock bumper support back on. I would like to fab a support that will do the same job as the old one but fit around the ic while leaving ample room to fit the bumper cover back on. Any design ideas/reccomendations would be greatly appreciated.
Made a stand for my new bender. JD2 decided not to tell me it's not included and there stand is $160. So I made a replica for 1/3 the price 
I haven't welded mild steel in like 6 years haha. And I didn't have the things needed to clean the surface so my welds didn't come out all that great. I wouldn't be satisfied if this was for a customer but it's just a stand and it's mine lol.
Cleaned up a bit
I haven't welded mild steel in like 6 years haha. And I didn't have the things needed to clean the surface so my welds didn't come out all that great. I wouldn't be satisfied if this was for a customer but it's just a stand and it's mine lol.
Cleaned up a bit
Kensi
Driver