negggativee
---------- Post added at 03:44 PM ---------- Previous post was at 02:50 PM ----------
ok. i tried 2 different wheels, bolted down correctly, the 2nd part of the axle going to the diff is disconnected, but the spline shaft going onto the hub is still there, also the caliper is disconnected to allow the wheel to spine alot easier, say your kneeld down to the wheel and start spinning it, if you look down to the bottom of the wheel, you can see it going in and out, creating a wobble. if you shake the wheel tho, there is NOT any play from a wheel bearing. could having toe rods and traction rods adjustable and not be aligned properly cause it to create a wobble like that?