SpdRcrChk
Spectator
What You Will Need:
2" PVC Cap (you can find these at places like Home Depot. The cap should be about 2.5" Overall Diameter)
Valve Stems
Silicone
Drill
Steps (easy part!)
• Drill a hole on the cap that's the same size as the valve stem (center, thinner part)
• Put in the valve stem and make sure to seal it well with the silicone.
• Hose clamp it on to the turbo inlet / inlet piping (make sure that you clamp it on real tight. If you don't, it's likely to blow off once you pressurize it).
• Add air pressure (u know...use a compressor ) and listen' for leaks.
Voila!! You're now a mechanic or somethin'
2" PVC Cap (you can find these at places like Home Depot. The cap should be about 2.5" Overall Diameter)
Valve Stems
Silicone
Drill
Steps (easy part!)
• Drill a hole on the cap that's the same size as the valve stem (center, thinner part)
• Put in the valve stem and make sure to seal it well with the silicone.
• Hose clamp it on to the turbo inlet / inlet piping (make sure that you clamp it on real tight. If you don't, it's likely to blow off once you pressurize it).
• Add air pressure (u know...use a compressor ) and listen' for leaks.
Voila!! You're now a mechanic or somethin'