Search results

Walbro is the easiest and cheapest, If you wanted a OEM replacement pump it should be a 300zx it flows more than a supra pump.

what waste gate are you using? does it do it with no boost controller hooked up? Is the boost controller hooked to the right port? where are you getting the signal from? where are you located?

I can get it done, located in Ft. lauderdale number sent in pm.

Innovate is alot better than the aem gauge, Plus they offer the upgraded sensor for "race" gas.

http://www.alldata.com/home/

vacuum leak, intercooler leak, bov leak, tps disconnected?

Did you just wire this? If not why was the harness disconnected?

No Problem.

no matter what publix I go to it takes 15min to get a sub, even if I am the only one there.

contact Andres @ R.A.W. to get it wired 954-257-9787 STP for dyno and tuning 954-260-9380

google heim joint spacers or rod end spacer, get yourself some calipers and start measuring, they are about $10 for each spacer so you will spend about $40 plus shipping. How much does godspeed want for new ends? Here is a start http://www.midwestcontrol.com/catdisplay_short.php?pg=228

Thought I was the only one.

+1

Richard has done a few, just bring him the car with motor in it and the turbo and waste gate he will make the manifold, he uses schedule 10 material so it will be strong as well. He can do all the intercooler piping and downpipe at the same time so everything fits.

Richard @ Rich Auto Works 954-562-0531 can make what ever you need.

lucas 80-90. How is the shifting with the shockproof oil on regular transmissions? I've used it on dog boxes before and loved it.

Labor hours the book says X shop labor rate= Cost.

Thats what I was going to say, I had removed mine and when I put it back on I didn't get the fuel smell anymore.

charcoal/ purge canister hooked up?

what motor? Check FSM!