new clutch slipping?

Slave could be sticking or guy didn't give two shits about cleaning the flywheel on install.
 
This is EXACTLY what i was thinking. also its not slipping crazy that i cant drive it.for example. i needed to speed up a bit to move over for a fire truck. i acelarated a bit and it slipped then grabbed. so yea.
 
Im not gonna punch him in the face. he is a cool person. im not blaming him or anything. im just asking to see why it would be slipping if its new
 
it cant be air if the flywheels is toasted then machine it or grab another. Hydraulics ( slave master) are only used to disengage not engage. so its not that either they clutch or flywheel. IS THERE SLACK IN THE PEDAL VERY IMPORTANT. It cant be adjusted to tight or it will slip
 
im betting your flywheel is glazed over or there is grease or oil on your clutch disc
 
I'm having the same problem but I think the push rod might be too tight on mine its very touchy though if I loosen it a little the clutch engages too low
 
You must log in or register to reply here.
Back
Top Bottom