fuel pump installed. car wont start

G

GuTi

Member
So I replace my stock fuel pump on my s13 to a 255 walbro.

Installed and rewired. I get in the car. Prime the fuel pump ( primes right up) and go crank and nothing. Tried a couple more times and does not start just cranks. I took it back out. Redid the connections double checked everything and it seemed fine, gas even poured out of the hoses connected to the fuel pump wen I took them off again. Cant seem to find the problem. can anyone help??
 
Yea. it primes and u can hear it. Hoses are on tight. Im pretty sure if the fuse was blown it wouldnt prime?
 
GuTi said:
Yea. it primes and u can hear it. Hoses are on tight. Im pretty sure if the fuse was blown it wouldnt primim dont mean tie?
Click to expand...

not tight, right. did you put the hoses back on the correct nipples from the pump assembly. if you put them backwards itll send full up the return line instead of the feed line
 
Im pretty sure the lines are on correctly but ill triple check

---------- Post added at 06:43 PM ---------- Previous post was at 06:37 PM ----------

Lines are on correctly just checked
 
fuel pump is bad most likely I had one that primed, but did not send fuel, I replaced it and boom perfect.
 
Fixed! I guess my battery didnt have enough cranking power. Hooked up jumpercables and was cranking while giving it gas and it finally came to life!
 
You must log in or register to reply here.
Back
Top Bottom