Brake System Failure...**** help me plz

[etxxz]

Brake System Failure...haynes no help

There's two problems: ----->
1) Bleeding system: EDIT: just re-bled again don't know if done correctly, but same thing, the pedal is waaay to spongy. possibly master brake failure? its not leaking.
(1caliper at a time, from farthest to closest from master cyl. bro pumps pedal while pressurized lq gushes and then i close the screw when enough has flushed out and move onto next caliper??????)

2) Passenger rear caliper is always engaged... EDIT: Problem solved and with it everything i wrote after. ty for pm!!

"everyday i learn something new"
-you, your neighbor, your mom and me too

 

[S13 Slide]

brake master cylinder whats the condition leaking? might need a new one its OLD>

 

[S13 Slide]

ty ty ty ty ty!!!
i edited first message to keep you from wasting lots of time. ty!!!

What did it end up being the problem?

 

[etxxz]

take the rotor out, take it to get resurface. get caliper, make sure the pins are well oiled, put everything back together and set, mad i do things like that in like 20 minutes. that shows you how many times i have done it. remember you will need needle nose plyers and to open the *BLEEDER* to be able to push the piston in.

ok.
the caliper's got no pins so the pads just kinda fall in place. i used a 13/16 wrench to turn/push the piston in...not like it reqs much force anyways. ty man

 

[Silky Johnson]

Before You Resurface It Make Sure You Have The Minimum thickness Allowed Its On the rotor... Grab An open Ended Wrench Thats The Size of The minimum Thickness If It Fits You Need A New Rotor if Not You Can Cut It Safely.... BTW When You Changed the Pads Did You Compress The Piston?