Best Manual Boost Controller Ever!! FUK TURBOXS

If it's like that then you should just get a real manual boost controller. (Even though it doesnt take a genious to put together a HD mbc)
 
not really its a simple design that works...if you wanna make it look pretty put a different knob on the thing, hide it behind the dash, extend the screw and put a different know. bro its size and functionality ftw....supposing it does actually work :bigthumbu
 
you im going to home depot right now to buy(steal) the parts, make it and install it on my car, im post if it really works
 
It will explode and your pistons will shatter along side your hopes and dreams.

Nah, that MBC is about as good as an MBC can get sans fancy in dash control features and what not. If you want all that, get an EBC. I posted that link in case you were the type that likes to build little things like that. Its something I would do (wrong) but still have fun trying. :D
 
well, i told you i would try it out and give my input, i went to homedepot, but they didnt have all the parts to make either version of the mbc, so i used a pressure regulator valve for and air compressor(it has an 1/4 opening) then threaded brass 1/4 hose barbs to each end. i then drill a really small hole for a pressure release(i dont know why but my buddy said i had to have it) with the valve wide open i used to run 7psi, now its 10psi(i guess the pressure release hole is acting like a small wastegate t, Ill probly close the hole up so i can adjust boost with the valve since with the hole open my vacuum is higher-me no like-) I then turned the nob closed alittle and it went to 15psi. So this really works, i have no boost spikes or anything. This is some real NR-TECH for ya!! but dont hate, it work.
 
drftns14 said:
well, i told you i would try it out and give my input, i went to homedepot, but they didnt have all the parts to make either version of the mbc, so i used a pressure regulator valve for and air compressor(it has an 1/4 opening) then threaded brass 1/4 hose barbs to each end. i then drill a really small hole for a pressure release(i dont know why but my buddy said i had to have it) with the valve wide open i used to run 7psi, now its 10psi(i guess the pressure release hole is acting like a small wastegate t, Ill probly close the hole up so i can adjust boost with the valve since with the hole open my vacuum is higher-me no like-) I then turned the nob closed alittle and it went to 15psi. So this really works, i have no boost spikes or anything. This is some real NR-TECH for ya!! but dont hate, it work.
Click to expand...
that is the worst....me n z4k made one to get by befor and all we could get is spikes n high boost numbers because if you turn the knob jus a hair to much yur boost numbers will b insane..its not accurate and not easy to set..pay the 75 bucks n geta XSmbc from murrays.it works dreams..i personally dont lik mbc's because i uset to use a electronic boost controller..where its 7lbs for dailying...but if sum fool tryd me it was 14lbs on a flik of a switch hahaha

and on another 2 cents note...u get what u pay 4..and playin with boost can b exspensive
 
You must log in or register to reply here.
Back
Top Bottom