will a lsd from a 1990 300zx fit my s13???

welded is the way to go

if you say its too hardcore for daily driving then gtfo

ive been welded daily for two years
 
as long as its from a non turbo model with the right axles youll be fine. the twin turbo ones have the gear ratio that will slow you down

240sx W/ LSD: No mods needed if it is NON ABS
300ZX 90+ Non Turbo: Needs new output flanges (4.08)
300ZX 90+ Turbo: Needs new output flanges and gears are higher (3.69)
Infiniti J30 95+: No mods needed (3.96)
Infiniti J30 pre-95: Needs new output flanges
Infiniti M30: No mods needed
Infiniti Q45: No mods needed (3.69)

output flanges = new axles. in this case 5 bolt
 
Last edited:
u need j30 axles otherwise, you will have to put one of the s13 6hole outputs on the driverside of the pumpkkin, and use one 300z axle and one 240 axle...worked for me...but like it has been said b4 need the right axles
 
A 90+ TT diff will not work. its not even an r200. youd need to swap the subframe which is not a direct swap anyway.
 
Yea the non-turbo will fit just get j30 axles 5bolt, I used to have tht on mys14. but Id rather weld yours or j30.. z32 owners beat on there cars compared to j30s
 
any r200v will work in a stock s13 housing u just need 6 bolt output shafts or 5 bolt out put shafts with 5 bolt axles
 
You must log in or register to reply here.
Back
Top Bottom