help aiming my h.i.d.'s...

carcrazee

carcrazee

Driver
..i have h.i.d.'s on my s13 240, and i have them aimed by adjusting the flip up motors for the headlights..its bothering me cuz i have the headlights up all the time....my question is how do i get behind the headlights so i can adjust it properly so i can put my headlights down...
 
There are two screws on the front Of the headlight one under the other on the side ( fender side) you will see on the plastic cover that it has a cutout where the screws are( to lower tighten the bottom one )
 
MiamiGetLow said:
There are two screws on the front Of the headlight one under the other on the side ( fender side) you will see on the plastic cover that it has a cutout where the screws are( to lower tighten the bottom one )
Click to expand...

that works but most of the time the bracket bends and the screw pops out. try getting a caster shield to reduce some of the glare
 
Regardless of what you do, you will blind the fuck out of people with the glare.

Do yourself a favor and take that crap out. You aren't gaining any useful visibility, and that shit just looks wiggity.

Want to do this right, get some cheap H4 housings, crack them open and retrofit some proper xenon projectors in there. Wow i can see! Wow im not getting people flashing their highbeams all day! \o/
 
you can either custom make projector housings, or you can make a cut off so that the light doesnt stray above a certain point. i did it on my old mazda and i never got flashed. however i gained a lot of visibility with my hid's but mazda headlights are famous for remarkably low light outputs
 
YucA said:
Regardless of what you do, you will blind the fuck out of people with the glare.

Do yourself a favor and take that crap out. You aren't gaining any useful visibility, and that shit just looks wiggity.
Click to expand...

im thinkin bout sellin them idk,, to much electrical shit for me lol
 
MiamiGetLow said:
There are two screws on the front Of the headlight one under the other on the side ( fender side) you will see on the plastic cover that it has a cutout where the screws are( to lower tighten the bottom one )
Click to expand...

...one of the screws are stripped but i know wat to now thanx
 
You must log in or register to reply here.
Back
Top Bottom